Lava Benco S1 Pro AE9260 FRP Reset File & Tool NO Risk 100% Work
This Firmware is Not Without a Password or is Free. This Rom is Only For Paid Premium
Admin: GSM BORHAN
Call: 01884821503 –Bkash 01854302180
Select "Unisoc" platform from the tab menu in the upper left side of the software
Go to the "Service" tab
Select your phone model in the right drop-down menu
Universal Loaders:
If the phone from a drop-down list doesn't work, try the generic platform loader from the (Unisoc) category.
Turn the phone OFF
Select the “USB (autodetect)” port
Press the “Remove FRP” button
Set the phone to the special mode:
Press and hold the "VOL -" while inserting the USB cable
In some cases, a different key combination or connection via a test point may be required.
Install phone drivers (only if the phone is connected for the first time).
Connect the phone to the PC
The message "Removing FRP lock...Done" indicates that the procedure has been completed successfully
Disconnect the device
If your device isn't listed among the supported models, but you have a flash file for it in the original *.pac format, you can attempt to perform a service operation.
Service such a device using loaders extracted from flash files, by following these steps:
Select the "Unisoc" platform from the tab menu in the upper left corner of the software.
Go to the "Service" tab.
Select the "USB (autodetect)" port.
Turn the phone OFF
Select "(PAC)" from the right drop-down menu.
Select “Loader selection…”
Press the "Remove FRP" button.
The program will prompt you to choose the flash file in the original *.pac format.
Set the phone to the special mode:
Press and hold the "VOL -" button while inserting the USB cable.
In some cases, a different key combination or connection via a test point may be required.
Connect the phone to the PC
Install phone drivers (only if the phone is connected for the first time).
When you see the message "Removing FRP lock...Done," it indicates that the procedure has been successfully completed.
Disconnect the device.
If the service operation is successful, share the log on the official Sigma forum.