Walton NEXG N71 FRP Reset File & Tool NO Risk 100% Work

Walton NEXG N71 FRP Reset File & Tool NO Risk 100% Work

Walton NEXG N71 FRP Reset File & Tool Walton NEXG N71 FRP Reset File Google Account Recovery Walton NEXG N71 Bypass Frp Unlock Tool Remove FRP Bypass Apk Walton NEXG N71 FRP Remove File

Walton NEXG N71 FRP Reset File

Walton NEXG N71 FRP FRP Reset File & Tool NO Risk 100% work

This Firmware is Not Without a Password or is Free. This Rom is Only For Paid Premium

Admin: GSM BORHAN
Call: 01884821503 –Bkash 01854302180

Select "Unisoc" platform from the tab menu in the upper left side of the software

Go to the "Service" tab

Select your phone model in the right drop-down menu

Universal Loaders:

If the phone from a drop-down list doesn't work, try the generic platform loader from the (Unisoc) category.

Turn the phone OFF

Select the “USB (autodetect)” port

Press the “Remove FRP” button

Set the phone to the special mode:

Press and hold the "VOL -" while inserting the USB cable

In some cases, a different key combination or connection via a test point may be required.

Install phone drivers (only if the phone is connected for the first time).

Connect the phone to the PC

The message "Removing FRP lock...Done" indicates that the procedure has been completed successfully

Disconnect the device

If your device isn't listed among the supported models, but you have a flash file for it in the original *.pac format, you can attempt to perform a service operation.

Service such a device using loaders extracted from flash files, by following these steps:

Select the "Unisoc" platform from the tab menu in the upper left corner of the software.

Go to the "Service" tab.

Select the "USB (autodetect)" port.

Turn the phone OFF

Select "(PAC)" from the right drop-down menu.

Select “Loader selection…”

Press the "Remove FRP" button.

The program will prompt you to choose the flash file in the original *.pac format.

Set the phone to the special mode:

Press and hold the "VOL -" button while inserting the USB cable.

In some cases, a different key combination or connection via a test point may be required.

Connect the phone to the PC

Install phone drivers (only if the phone is connected for the first time).

When you see the message "Removing FRP lock...Done," it indicates that the procedure has been successfully completed.

Disconnect the device.

If the service operation is successful, share the log on the official Sigma forum.

Previous Post Next Post

Comments

Featured Posts